A Common Problem

A lot of times, it can be a struggle to get body work straight.  The area doesn’t feel quite right, it doesn’t block quite right. Everyone fights it from time to time. 
♦️More often than not, I’ve found the problem is usually the whole are is still too low.

♦️Filling the area again and block sanding it out usually corrects it. 

♦️Obviously the less filler used the better. At the same time, the body work does need to be straight and correct. Don’t be afraid to add more filler. It’s probably what the problem is you’re fighting.

♦️Use aluminum flat stock or c-channel as a guide to help show you where the low and high areas are. 


Leave a comment